Drive 4X Steel puls S D200
Description
- Wire feeder housing: Plastic
- MIG/MAG wire feeder for Taurus Steel puls S
- Pulsed MIG/MAG welding, MIG/MAG welding, MMA welding and gouging
- Significantly less spatter formation and therefore less finishing work thanks to the pulse function
- Spool diameter up to 200 mm
- D200 spool holder
- Can pass through manholes
- Low weight thanks to the plastic casing
- Adjustment of the gas quantity directly on the wire feeder via the gas control valve
- Adjustment of the gas quantity directly on the wire feeder via the gas control valve
- Adjustable start and end-crater functions
- Protected arrangement of connections for intermediate hose packages and control cables
- Non-specialist personnel can change hose packages without tools
- 4-roll drive Equipped for 1.0 mm + 1.2 mm steel wires
Control
- Twin-knob operation: configuration of operating point using wire feed speed and welding voltage
- Locking of control unit for e.g. transport at the push of a button
- Adjusting the arc dynamics (choke effect) from soft to hard
Operation mode | Manual operating point adjustment |
Welding process | MIG/MAG |
MMA | |
Gouging | |
Operating modes | Non-latched |
Latched | |
Parameters in display | Welding current |
Welding voltage | |
Wire feed speed | |
Functions | Arc dynamics (choke effect) |
Technical data
Duty cycle 40 °C | 550 A / 60 % |
430 A / 100 % | |
Wire feed speed | 0.5 m/min - 25 m/min |
19.685 ipm - 984.253 ipm | |
Factory-installed roll equipment | 1,0 + 1,2 mm / Steel |
Spool diameter | D200 |
Torch connection | Euro torch connector |
Protection classification | IP23 |
Test mark | |
EMC class | A |
Dimensions (L x B x H) | 576 mm x 214 mm x 310 mm |
22.7 inch x 8.4 inch x 12.2 inch | |
Weight | 13.8 kg / 30.4 lbs |
Standards | IEC 60974-1, -5 and -10 CL.A |
Documents
Accessories
Show all
Components and accessories
Welding torches
Suitable for
Show all
MIG/MAG welding machines